StarTech.com

2.5in and 3.5in 40 Pin Male IDE to SATA Adapter Converter

Connect your SATA drive to an IDE motherboard

Product ID: IDE2SAT

22,99 € EUR exc VAT
22,99 € EUR inc VAT

Overview

Technical Specifications

Warranty Information
Warranty Lifetime
Hardware
Chipset ID Marvell - 88SA8052
Compatible Drive Types SATA
Drive Size 2.5in & 3.5in
Interface IDE
Performance
Maximum Data Transfer Rate 133MB/sec
RAID No
Connector(s)
Connector Type(s) 1 - IDE (40 Pin, EIDE/PATA) Male
1 - SATA Data & Power Combo (7+15 pin) Receptacle
1 - SP4 (4 pin, Small Drive Power) Male
Software
OS Compatibility OS independent; No software or drivers required
Environmental
Humidity 15~90% RH
Operating Temperature 5°C to 50°C (40°F to 122°F)
Storage Temperature -25°C to 80°C (-13°F to 176°F)
Physical Characteristics
Enclosure Type Steel and Plastic
Product Height 23 mm [0.9 in]
Product Length 75.5 mm [3 in]
Product Weight 15 g [0.5 oz]
Product Width 20 mm [0.8 in]
What's in the Box
Included in Package 1 - IDE to SATA adapter
1 - LP4 Molex to SP4 Power Cable
1 - Instruction Manual
Supports any operating system.
No additional drivers or software required.

Certifications

Related Products

IDE to SATA Adapter Converter
PATA2SATA2
IDE to SATA Adapter Converter

Connect 2 SATA hard drives to an IDE motherboard or card

18,99 € exc VAT
18,99 € inc VAT
40 Pin Female IDE to SATA Adapter Converter
IDE2SAT25
40 Pin Female IDE to SATA Adapter Converter

Allows connection of a SATA device to an IDE motherboard or card

17,99 € exc VAT
17,99 € inc VAT

Product Support

Frequently Asked Questions

Before You Buy

Note: For more information on how to detect an IDE hard drive, visit http://www.startech.com/faq/hard_drive_accessories_ide_detection.

Older IDE drives are not supported by current StarTech.com products. Typically, these drives were made earlier than the mid-to-late 1990s and are smaller than 1 Gigabyte in size.

There are a number of reasons that older IDE drives may not be detected, including the following:

  • The drive uses PIO (Programmed Input/Output) mode and not DMA (Direct Memory Access).

  • The drive is non-ATA or is using an ATA mode that predates the chipset's compatibility (usually older than ATA-4).

  • The sector size is not 512 bytes.

Unfortunately there is no workaround in these situations. An older system or an older IDE controller card must be used to access older IDE drives.