Product ID: SLSATAF20
In stock: 337
The SLSATAF20 Slimline SATA to SATA with LP4 Power Cable (20-inch) features a SATA data receptacle and a LP4 power connection on one end, and a Slimline Serial ATA receptacle on the other - allowing you to connect a slim SATA drive to a computer motherboard that does not have a Slimline connection available.
Supporting full SATA 3.0 bandwidth of up to 6Gbps when used with SATA 3.0 compliant drives, this innovative adapter cable provides you with the connections needed to simplify the migration to Slimline SATA-equipped drives.
Constructed of only top quality materials and designed for optimum performance and reliability the SLSATAF20 is backed by our lifetime warranty.
|Connector(s)||1 - Connector A||Slimline SATA (13 pin, Data & Power)|
|1 - Connector B||SATA (7 pin, Data)|
|LP4 (4 pin; Large Drive Power)|
|Hardware||Cable Jacket Material||PVC - Polyvinyl Chloride|
|Packaging Information||Shipping (Package) Weight||22.0 g [0.8 oz]|
|Package Length||5.0 cm [2.0 in]|
|Package Width||1.0 cm [0.4 in]|
|Package Height||18.4 cm [7.2 in]|
|Performance||Type and Rate||SATA III (6 Gbps)|
|Physical Characteristics||Weight of Product||22.0 g [0.8 oz]|
|Product Width||1.4 cm [0.6 in]|
|Product Height||6.0 mm [0.2 in]|
|Cable Length||508 mm [20.0 in]|
|Product Length||50.8 cm [20.0 in]|
|What's in the Box||1 - Included in Package||20in Slimline SATA to SATA with LP4 Power Cable Adapter|
When you troubleshoot issues with a SATA cable, there are some quick tests that you can complete to rule out potential problems. You can test to make sure that the following components are working correctly and are not the source of the issue:
Hard disk drive
Hard drive controller (for example, motherboard)
To test your setup components, try the following:
Use the hard disk drive, hard drive controller, and SATA cable in another setup to see if the problem is with the components or the setup.
Use a different hard disk drive, hard drive controller, and SATA cable in your setup to see if the problem persists. Ideally, you should test a component that you know works in another setup.
When you test the hard disk drive, hard drive controller, and SATA cable, it is recommended that you do the following:
Make sure that the hard drive is spinning without the SATA cable attached. The power cable should make the drive spin if it is a mechanical drive and not a solid state drive.
If your operating system is not detecting the hard disk drive, make sure that the drive is formatted with a partition (for example, NTFS or FAT32). If you are using a computer running a version of Windows, a drive letter must also be assigned to the hard disk drive.
For more information about how to initialize a drive, refer to the following FAQ: https://www.startech.com/support/faqs/technical-support?topic=hard-drives#initialize-hard-drives.