The ESATAPLT1LP Low Profile SATA to eSATA plate adds external data support to any existing Serial ATA controller, allowing you to connect external SATA (eSATA) storage to a computer. With support for data transfer rates of up to 6Gbps, this external SATA plate allows you to take advantage of the increased data integrity provided by external hard drives or RAID devices that support eSATA connections.
The adapter plate can be mounted to the rear panel of the computer case, providing straightforward eSATA to SATA connections and allowing users to connect their eSATA device (hard drive enclosure, etc.) to the provided eSATA port which is an extension of the motherboard SATA data connector.
Constructed of only top quality materials and designed for optimum performance, and reliability the ESATAPLT1LP is backed by our lifetime warranty.
|Connector(en)||1 - Connector A||SATA (7-polig, data)|
|1 - Connector B||eSATA (7-polig, data)|
|Fysieke eigenschappen||Gewicht product||35 g [1,2 oz]|
|Kabellengte||30,5 cm [12,0 in]|
|Lengte product||30,5 cm [12,0 in]|
|Hardware||Type kabelmantel||PVC - Polyvinyl Chloride|
|Verpakkingsinformatie||Verzendgewicht (verpakt)||35 g [1,2 oz]|
|Package Length||12,1 cm [4,8 in]|
|Package Width||18 mm [0,7 in]|
|Package Height||22,6 cm [8,9 in]|
|Wat wordt er meegeleverd||1 - Meegeleverd||1ft Low Profile SATA to eSATA Plate Adapter|
When you troubleshoot issues with a SATA cable, there are some quick tests that you can complete to rule out potential problems. You can test to make sure that the following components are working correctly and are not the source of the issue:
Hard disk drive
Hard drive controller (for example, motherboard)
To test your setup components, try the following:
Use the hard disk drive, hard drive controller, and SATA cable in another setup to see if the problem is with the components or the setup.
Use a different hard disk drive, hard drive controller, and SATA cable in your setup to see if the problem persists. Ideally, you should test a component that you know works in another setup.
When you test the hard disk drive, hard drive controller, and SATA cable, it is recommended that you do the following:
Make sure that the hard drive is spinning without the SATA cable attached. The power cable should make the drive spin if it is a mechanical drive and not a solid state drive.
If your operating system is not detecting the hard disk drive, make sure that the drive is formatted with a partition (for example, NTFS or FAT32). If you are using a computer running a version of Windows, a drive letter must also be assigned to the hard disk drive.
For more information about how to initialize a drive, refer to the following FAQ: https://www.startech.com/support/faqs/technical-support?topic=hard-drives#initialize-hard-drives.