This MPO/MTP fiber optic cable houses 12 fibers and lets you interface between different networking devices of varying speeds. For example, you can set up a one-to-one connection between two 40Gbps switches or servers. Alternatively, you can connect a 40Gbps switch and break out the 40Gbps into six duplex 10Gbps LC connections on a patch panel or network cassette, which then fans out to individual 10Gbps devices.
The MTP connector provides twelve times the density of an SC connector and saves circuit card and rack space. Plus, the push-and-pull tabs optimize accessibility, by letting you install or remove the connectors with one hand without using additional tools.
The MTP to MTP cable is housed in a plenum-rated jacket and is ideal for installations where CMP fire rating is required.
Each OM3 fiber cable has been individually tested for insertion loss and return loss. The full test report is included in each cable bag.
The MPO12PL1M from StarTech.com is backed by a lifetime warranty.
|Connector(en)||1 - Connector A||MPO/MTP|
|1 - Connector B||MPO/MTP|
|Kabellengte||100 cm [39,4 in]|
|Lengte product||100 cm [39,4 in]|
|Breedte product||14 mm [0,6 in]|
|Hoogte product||7 mm [0,3 in]|
|Gewicht product||16 g [0,6 oz]|
|Hardware||Brandbestendigheid||CMP goedgekeurd (luchtruimtes)|
|Verpakkingsinformatie||Verzendgewicht (verpakt)||28 g [1,0 oz]|
|Package Length||22 cm [8,7 in]|
|Package Width||20 cm [7,9 in]|
|Package Height||10 mm [0,4 in]|
|Wat wordt er meegeleverd||1 - Meegeleverd||fiber optic cable|
UPC and APC are fiber cable connector types. UPC (Ultra Physical Contact) connectors have a fiber connector end face that has been polished to be dome-shaped. This results in light that can be reflected straight back to the source.
APC (Angled Physical Contact) connectors have a fiber connector end face that has been polished at an eight degree angle. This results in a reduced amount of light that is reflected between the two connected fibers.
StarTech.com fiber cables use UPC connectors.