Product ID: SATA12LA1
The SATA12LA1 Left Angle (90-degree) SATA Cable features a standard (straight) SATA receptacle as well as a left-angled SATA receptacle, providing a simple 12-inch connection to a Serial ATA drive, with full SATA 3.0 bandwidth support of up to 6Gbps when used with SATA 3.0 compliant drives.
The left-angled SATA connection enables you to plug in your Serial ATA hard drive in hard to reach areas or tight spaces, while the low profile and flexible design of the cable improves airflow and reduces clutter in your computer case, helping to keep the case clean and cool.
Constructed of only top quality materials and designed for optimum performance and reliability this 12" SATA cable is backed by our lifetime warranty.
As an alternative, StarTech.com also offers a (SATA12RA1), which provides the same simple installation as this left angled SATA cable, but allows the cable to connect to the SATA drive from the opposite direction.
|Connector(s)||1 - Connector A||SATA (7 pin, Data)|
|1 - Connector B||SATA (7 pin, Data)|
|Environmental||Operating Temperature||20°C to 80°C (68°F to 176°F)|
|Storage Temperature||24°C to 25°C (75.2°F to 77°F)|
|Humidity||50% relative humidity|
|Hardware||Number of Conductors||7|
|Cable Jacket Material||PVC - Polyvinyl Chloride|
|Packaging Information||Package Height||0,6 mm [0,0 in]|
|Package Length||12,8 cm [5,0 in]|
|Shipping (Package) Weight||17,0 g [0,6 oz]|
|Package Width||22,0 cm [8,6 in]|
|Performance||Type and Rate||SATA III (6 Gbps)|
|Physical Characteristics||Product Height||6,2 mm [0,2 in]|
|Weight of Product||12,0 g [0,4 oz]|
|Product Width||1,2 cm [0,5 in]|
|Connector Style||Straight to Left Angle|
|Wire Gauge||26 AWG (0.404 mm)|
|Cable Length||304,8 mm [12,0 in]|
|Product Length||30,5 cm [12,0 in]|
|What's in the Box||1 - Included in Package||12in SATA to Left Angle SATA Serial ATA Cable|
When you troubleshoot issues with a SATA cable, there are some quick tests that you can complete to rule out potential problems. You can test to make sure that the following components are working correctly and are not the source of the issue:
Hard disk drive
Hard drive controller (for example, motherboard)
To test your setup components, try the following:
Use the hard disk drive, hard drive controller, and SATA cable in another setup to see if the problem is with the components or the setup.
Use a different hard disk drive, hard drive controller, and SATA cable in your setup to see if the problem persists. Ideally, you should test a component that you know works in another setup.
When you test the hard disk drive, hard drive controller, and SATA cable, it is recommended that you do the following:
Make sure that the hard drive is spinning without the SATA cable attached. The power cable should make the drive spin if it is a mechanical drive and not a solid state drive.
If your operating system is not detecting the hard disk drive, make sure that the drive is formatted with a partition (for example, NTFS or FAT32). If you are using a computer running a version of Windows, a drive letter must also be assigned to the hard disk drive.
For more information about how to initialize a drive, refer to the following FAQ: https://www.startech.com/support/faqs/technical-support?topic=hard-drives#initialize-hard-drives.
Check out our review guidelines.